Engine Oil and Oil Filter Change

To change engine oil and oil filter:
• Run the engine until engine water temperature reaches 60 °C.
• Shut off the engine.
• Remove the crankcase plug, pour the oil to oil collection tank.
• Clean the oil filter head and dismount the filter using filter dismounting tool.
• Fill the new filter with clean engine oil.
• Lay a thin layer of engine oil to oil filter O-ring.
• Tighten the oil filter by hand until the rubber contacts with the gasket surface, and
then tighten the filter with filter tool for another round.
• Mount the crankcase plug with a new seal washer and tighten with 24 Nm torque.
• Fill the engine oil until H level.
• Start the engine in idle and check for leakage.
• After waiting for the oil to percolate for 5 minutes, premeasure the engine oil level
andrefill until H level if it has decreased.

Oil Level Control

You may reach the oil level control stick by opening the rear engine cap. For oil level control;

• Pull the oil level stick
• Wipe with a clean cloth
• Mount the stick and then pull again
• Check the oil level
• Fill until H level.